PDA

View Full Version : How do I use teensy 3.0 without the USB port?



Darcade
10-06-2013, 12:58 PM
Hey,

I just destroyed the sub port of my Teensy.....
I am not able to solder the usb hub back to the board because the solder points are destroyed.

Is there any other way to solder for example a USB-cable to the teensy?

I saw that some soldering points on the bottom of the teensy.

And I watched at the schematic and saw that there are some points directly connected to the USB.

When I look at the schmeatic I would choose these points to solder my USB cable to, but where can I find these points on the teensy?

998

I hope you will help me.

lg Darcade

PaulStoffregen
10-06-2013, 02:16 PM
Check this thread.

http://forum.pjrc.com/threads/19336-How-to-repair-a-broken-off-Teensy-3-0-USB-connector