I'm trying to get an Arduino Ethernet shield I had lying around to work with my Teensy 3.1
I realise its not the newest tech but from a bit of googling it looked like it should (probably) work.
The shield isn't an official one but it is this one http://www.hobbytronics.co.uk/arduino-wiznet-shield
I wired it up like this: http://www.epyon.be/wp-content/uploads/2013/07/teensy_ardeth.jpg
with the exception of the top left pin on the shield which I don't have.
I'm trying to get the webserver sketch to work - I get 4 lights on the shield but I can't ping the ip address and the Serial Monitor reports Server 0.0.0.0
I'm not really sure how I can work out what going wrong. Voltages seem ok on the power lines.
Any Suggestions? I have very probably made an obvious error!
I realise its not the newest tech but from a bit of googling it looked like it should (probably) work.
The shield isn't an official one but it is this one http://www.hobbytronics.co.uk/arduino-wiznet-shield
I wired it up like this: http://www.epyon.be/wp-content/uploads/2013/07/teensy_ardeth.jpg
with the exception of the top left pin on the shield which I don't have.
I'm trying to get the webserver sketch to work - I get 4 lights on the shield but I can't ping the ip address and the Serial Monitor reports Server 0.0.0.0
I'm not really sure how I can work out what going wrong. Voltages seem ok on the power lines.
Any Suggestions? I have very probably made an obvious error!