Eagle Package Audioboard

Status
Not open for further replies.
F

Frank B

Senior Member
Hi,

is there an existing EAGLE lbr for the Audioboard ?
If not: @Paul: could you post the dimensions/positions of all the mountingholes and pins ?
 
Frank B said:
could you post the dimensions/positions of all the mountingholes and pins ?
Click to expand...

All of these coordinates are "mils", or 1/1000th of an inch, relative to the lower left corner.

Mounting holes at 775,125 and 125,1325 and 1275,1325

Teensy GND pin at 50, 500

Headphone Jack (front, center axis) 15,200

Mic pins at 50,800 and 50,900

Line in/out connector:
InL = 500,1250
InR = 600,1250
InGND1 = 500,1350
InGND2 = 600,1350
OutR = 700,1250
OutGND = 800,1250
OutL = 900,1250
unused = 700,1350
unused = 900,1350

Board size is 1400,1450
 
Great, thank you.

Only the Volume-Pot is missing! Could you tell the exact position?

Audio Shield.png

I'll upload the library in the next days..

Edit: The diameter of the mounting-holes is .. ? (3.2mm ?)

Edit: picture updated
 
Last edited:
Ok, here it is.
(My first Eagle-Lib :D )
 

Attachments

  • Teensy_Audioshield.zip
    2.6 KB · Views: 116
Last edited:
Cool - this one would be similar and generally useful: https://www.oshpark.com/shared_projects/TG395I75

After hand wiring the 13 pins to the new touch ILI9341 I'm looking forward to getting three copies this board from OSH. Having an interface to power and choice pins could be handy.

Paul can you drop the dimensions/positions for this board?

Frank I'm new to Eagle (at least once I start I will be) if there a reference you found for point entry and guidelines for pad details and the process you used?
 
defragster said:
Cool - this one would be similar and generally useful: https://www.oshpark.com/shared_projects/TG395I75

After hand wiring the 13 pins to the new touch ILI9341 I'm looking forward to getting three copies this board from OSH. Having an interface to power and choice pins could be handy.

Paul can you drop the dimensions/positions for this board?

Frank I'm new to Eagle (at least once I start I will be) if there a reference you found for point entry and guidelines for pad details and the process you used?
Click to expand...

I'm new to Eagle too :) I had some german forum posts and googled..so that would'nt very useful for you.
But there are many tutorials online.

I think it would be better to have a lib for the ili9341-display in both sizes?
But on the other hand, it's only a 14-pin connector which is already done as "pinheader" with an existing lib.
 
Status
Not open for further replies.
Back
Top