I'm working on a Voice changer, for a costume
the Goals I have for it are as follows:
Only transmit audio when the button is pressed
Lower the Pitch of the voice being transmitted
add some white noise to the transmission to mimic radio a radio transmission
play a static burst when button is released
I have a Teensy 3.2 and an Audio Shield, I run the output to a powered external speaker. the Input is run to a mic breakout where I can either use normal electect mic or a BlueTooth receiver, that receives the signal from a transmitter that the mic is connected to.
now I have figured out how some of this will happen just learning how to implement said effects, and I'm looking for advice on how to proceed what functions to look into to achieve everything. I have basic electronics knowledge but minimal programming experience. Any help or advice is welcome
if anything else is needed to make what I'm saying clearer please don't hesitate to ask
Donny
the Goals I have for it are as follows:
Only transmit audio when the button is pressed
Lower the Pitch of the voice being transmitted
add some white noise to the transmission to mimic radio a radio transmission
play a static burst when button is released
I have a Teensy 3.2 and an Audio Shield, I run the output to a powered external speaker. the Input is run to a mic breakout where I can either use normal electect mic or a BlueTooth receiver, that receives the signal from a transmitter that the mic is connected to.
now I have figured out how some of this will happen just learning how to implement said effects, and I'm looking for advice on how to proceed what functions to look into to achieve everything. I have basic electronics knowledge but minimal programming experience. Any help or advice is welcome
if anything else is needed to make what I'm saying clearer please don't hesitate to ask
Donny