Hi,
I've just soldered up my Teensy 3.6 to try to use my segger JLink. I followed the pinout information here: https://www.kickstarter.com/project...-36/comments?cursor=14178744#comment-14178743
Unfortunately, while I have tied the DE pin to GND, my oscilloscope still shows sporadic logic-level signals on the DD and DC lines without my programmer connected, so it is clearly being driven and not in high impedance. Is this feature not supported yet?
Thanks,
Jeremy
I've just soldered up my Teensy 3.6 to try to use my segger JLink. I followed the pinout information here: https://www.kickstarter.com/project...-36/comments?cursor=14178744#comment-14178743
Unfortunately, while I have tied the DE pin to GND, my oscilloscope still shows sporadic logic-level signals on the DD and DC lines without my programmer connected, so it is clearly being driven and not in high impedance. Is this feature not supported yet?
Thanks,
Jeremy