bk40's latest activity

Thanks, I hated the cc restriction at the start but it was what I said I’d do so stuck it out. I have looked and started preparing for syx and nrpn but worried a switch will derail me just now. So parked that until I get software at a good...

I was just looking at a supersaw build myself, my plan was to go Pico per DCO and feed analogue filters, I wonder if I could build your front end and attach it to a CS42448 TDM board for 8 individual outputs.

Thanks for that. Going to have a sit down after reading the other designs and most likely go for 2 designs. One modular and one desktop. I had the module one working but my poor soldering was constantly letting me down. Firmware will be same...

I’d be honoured if someone could get anything from this work, audiosynthsupersaw is separate and can be initiated and work with the audio library. I’ve worked on that for many hours so I will not messing with it for a bit. Hypersaw and square...

Thanks me too, I have more changes then I’ll get the videos sorted. Turns out I’m a good bit out of touch with matching recordings to clips. I’ve also designed the code to be hardware independent, it has an html editor, and juce version for daw...

Thanks I’ll have a read in to those, I like encoders for lots of things so happy to use them but cutoff and certain parameters I like to feel the feedback rather than click. So might be that I just have 4 assignable pots as my last hardware...

Thanks for the advice. I will do another example board and see what results I can get

I prefer the feel of programming the sounds with pots. But I’ve been through 3 builds already and even with the capacitors but always struggled But maybe I’m just using the wrong ones. Do you have any recommendations? And thanks I’ll look in...

Thanks paul. I’ll get the headers added

ILI9431 is the best supported, though many others work too. Muxing always adds some noise. There are a few things you can do the lessen the effect. 1: Use lower impedance pots, like 5K or 10K. Diminishing returns below 5K. 2: Add a ceramic...

Today I was working on patches and the cc updating each of the editors. I ended up just playing for a while There is another that I changed some filter modes during playing

Took your advice and ended up printing off the book. I have used AI many times to try and build something that would work. Finally I have a va filter bank. It’s designed to drop in to other projects. It’ll get better with time but I’ve been...

Hi, I’ve been lurking here for a while now and finally at a point that I feel brave enough to show the project. Started as a way of teaching myself the teensy. Project was to clone the behringer jt-4000. Be able to open its patches. Hit loads...