Diggable

I now have the midi notes showing up on Midi-Ox. working on having the computer recognize Teensy Midi

I have a midi Keyboard and I also have Ableton Live Software.

Per the code you sent, all 4 buttons work with pressed and released. That is what I was trying to do. Im positive on my first try I could not of come up with that code. I appreciate the help. Since the buttons are now working, I need to figure...

I got button 8 to work pressed not pressed. Trying to duplicate it for the other buttons. Here is what I did. void setup() { Serial.begin(38400); pinMode(8, INPUT_PULLUP); pinMode(7, INPUT_PULLUP); pinMode(6, INPUT_PULLUP)...

void setup() { Serial.begin(38400); pinMode(8, INPUT_PULLUP); } void loop() { if (digitalRead(8) == HIGH) { Serial.println("Button is not pressed..."); } else { Serial.println("Button pressed!!!"); } delay(3000); }

/* Buttons to USB MIDI Example You must select MIDI from the "Tools > USB Type" menu To view the raw MIDI data on Linux: aseqdump -p "Teensy MIDI" This example code is in the public domain. */ #include <Bounce.h> // the MIDI channel...

void setup() { Serial.begin(38400); } void loop() { if (digitalRead(8) == HIGH) { Serial.println("Button is not pressed..."); } else { Serial.println("Button pressed!!!"); } delay(3000); }

Quick question, as I reconnect the board wiring I have the serial monitor open. I get button pressed !!! but nothing else happens. If this is correct, shouldn't I get button pressed when initially pressed then released get button not pressed?

Good morning Gavin and thank you for your response. I have been working on the unit based on the information given, but what I have noticed is there are other components added to the tutorials given. That seems to complicate the basics. Although...

I got the press button code loaded and when the button is pushed it goes from off to on and stays on. it doesn't turn back off. So Im getting close... midi Ox is for windows. Is there a midi monitor for Mac? I have the Controller attached to wind...

Good morning. I followed the tutorial and I managed to set the button per the example and was able to get the 3.3 volts to the positive and negative of the button. Per my midi software. I'm using the 4 buttons to start, stop, next sequence...

I am very new to coding. Im an electrician by trade, my buttons are standard momentary buttons. Im trying to just set up 4 midi buttons to stop and start a sequence. No synth just for buttons. Im trying to understand how tis board works. I will...

Teensy 4.0 and not sure how to hook up the buttons. I plugged a push button between pin 0 and pin 1. Nothing happens.

Here is what I have connected. Teensy USB_MIDI is what its set up for.

/* Buttons to USB MIDI Example You must select MIDI from the "Tools > USB Type" menu To view the raw MIDI data on Linux: aseqdump -p "Teensy MIDI" This example code is in the public domain. */ #include <Bounce.h> // the MIDI channel...