Maklegend

Hi Andy, I initially tried soldering the components myself, but I had a hard time soldering the microprocessor. So I decided to have the board manufactured by a specialized company, so I'm pretty sure all the components are soldered correctly. I...

Hi Andy, thanks for your interest. Answering your question, I copied the Teensy's schematic. The only thing I changed is that I used a USB-C connector instead of the micro USB connector.

Thanks Mark for the reply. I've actually already consulted that section, but unfortunately I haven't been able to resolve the problem. Using a DS213 oscilloscope, I noticed that I don't see the 24 MHz crystal oscillation, but I don't see it on an...

You can find the definitions for the blink codes <here> (scroll down to the "Troubleshooting & Diagnostic Blink Codes" section). Hope that helps . . . Mark J Culross KD5RXT

Hello everyone. This is my first question on this forum. I apologize in advance if this question has already been asked. I created my own project based on the Teensy 4.0 schematic. I've checked the connections several times. Instead of using a...