RomRom

Hello everyone, I wanted to correct a mistake I made in my previous message regarding the wiring. During the transition from the prototype to a cleaner version with soldering, I realized that I had used two different types of cable (a Grove...

Finally it works! I changed DMX lamps for my tests. This means that my DMX signal will not be interpreted by all the devices. The device in question that doesn't work is a Chinese 12v LED dimmer (DMX Decoder 512 4CH x 8A, LED Controller) that I...

Hi Shawn, Thanks for your help! I've tried removing the kTXPin lines and connecting the jumper wires directly: TX from the Teensy to TX2 and RX from the Teensy to RX2. Unfortunately, this didn't resolve the issue; I'm still not getting a usable...

I have made some tests to try to isolate the cause of the problem : - I have swapped the RS-485 module with the good one (Receiver). The problem persists. - RS485 module is correctly supplied with 3.3V. - I checked the XLR connector wiring...

Hello everyone ! I'm new to the community and I already thank you for all the solutions I was able to find for my old projects through this forum and I hope you will be able to help me again. I'm not an engineer, please be kind with to me 😁 My...