Hello TFT,
Thanks for checking up.
I had to go away for work for a few weeks, but I am back to working on this. For my 4.1, I tried the riverdi sample linked above (fixed the code I think), the rudolph, and yours, but the screen never showed...
The timing table on the 4.3" BT817 is different than the 5" BT817. I updated the GDSTx library with the table corresponding to the TFT that you have, it is in the datasheet. Since there are 14 parameters, of which 8 have a maximum, minimum and...
Hey TFTLCDCyg,
I used your comment from here to set up the connections from my display to my 4.1. Like your pictures, I did a similar setup like you did here. I use the same 20pin cable that goes to a breakout board, which then is soldered onto...
Hello. I have this Riverdi 4.3" capacative display. Datasheet link. BT817 chip programming guide.
I have used the Riverdi ardunio uno shield with this riverdi sample app/program to start. This one is similar to the Rudolf library. I also was...