Search results

  1. S

    Teensy 4.0

    Any possibility for getting a Teensy 4.0 with the micro SD connector built in?
  2. S

    What mpr121 library works with teensy 3.2?

    I think I got you confused. not the MPR12 library , but a Teensy 3.2 pin operating as a capacitive sensor made the interrupts fail
  3. S

    What mpr121 library works with teensy 3.2?

    When I used it, interrupts were hosed , I had previously set up a timer interrupt, and it never got called What does this library do to interrupts?
  4. S

    Using all Teensy3.x pins with a socket.

    IF they wanted to I could lay the board out . not a very big deal, but I would like to put a more robust MiniUSB on it.
  5. S

    Using all Teensy3.x pins with a socket.

    wow, this whole difficult project could be alleviated with a bigger Teensy with more SIP pads. If there is a schedule on that I would rather limit my projects to the SIP pins at hand until that happens.
  6. S

    USB host detection

    I just went through 2 hours of tearing my hair out when a USB cable was the culprit. I find that the MicroUSB is far less reliable than the MiniUSB and not much smaller on the PCB, I never use it on my own projects because of that . Is it possible to migrate Teensy boards to this connector?
Back
Top