Search results

Cheers for the details GremlinWrangler =) The project worked fine, I used only a single channel in through the line in pins. All 393 pixels were wired as a single strand in the end, my other fixtures were located further than though so were run off a seperate controller. Due to weather had to...

Nice work =) I had a problem where it wouldnt take audio in, but that was because I left some pins connected between the octo board and audio, so after those were snipped it was fine. *edit*just read your reply.... but for others! Im using the fastLED library and some patterns from...

***More edit. More commented. More optimising. Much more to go...... ** So ive got some code working a tad. Now to map it and tune it and see if I can actually make this happen 0.o Edit: Shifted pattern being called from audio update to end of main loop. Calling it from audio update results...

Heya Tbh I havent checked, the event Im doing it for soon and deadline approaches..... Heres the code so far. It basically takes the raw freq and changes it to 8 bands averaged to between 0 and 50. Its got a mode for low / high freq. But going to have it working with the leds first then tune...

Heya =) I'm running ~600 ws2812 pixels and wanted it to react to the music, basically have a hue range of 60ish (reds to yellows) and and have reds as deeper frequencies and yellows as higher frequencies. Im using the fastSPI library since I already have some good animations in it and im...

So I've been tasked to make some installations which require a warmer colour tone and fire like flickering and such. Project plan so far is 8 units comprising of an 10W RBG LED and an Amber LED with two ws2811 chips, one having two unused outputs. I've done this with high power LED's before...

I'll let you know if the new cables I get are the same. Looking forward to testing out the new code, I'll make a project report once I get some headway =) Cheers

Heya... First of all, many many many thanks to Paul and all contributors, making this so accessible, both in required skills and cost, much kudos =) Interesting, I found my lights not working at all, after shortening the cable and having it work without the 74HCT245 shield, I checked my cat6...