Search results

  1. A

    Not understanding touchRead

    I started working on a capacitive touch sensing library for teensy which is non-blocking, the existing code is tested on a Teensy 3.6: https://github.com/arjuna-dev/TeensyTouch Credits to @Lalbert for the implementation idea...
  2. A

    Non-blocking (no wait) touch sense (touchRead) routine for Teensy 3.2

    I started working on such a library, the existing code is tested on a Teensy 3.6. https://github.com/arjuna-dev/TeensyTouch
  3. A

    Non-blocking (no wait) touch sense (touchRead) routine for Teensy 3.2

    I started working on such a library, the existing code is tested on a Teensy 3.6. https://github.com/arjuna-dev/TeensyTouch
  4. A

    SPISlave_T4

    How would I go about to shift out the bytes? I was writing some extra bytes to be able to then have the correct order but the output order was not consistent. The master is sending the CS and clock and allowing for 5 bytes to come through. For the following code I get consistent output (11, 15...
  5. A

    Teensy did not respond to a USB-based request to enter program mode.

    Code seems to matter in my case. I am having problems when using the SPISlave_T4 library. Are there any recommendations to troubleshoot such issues?
  6. A

    I2c communication issue between teensy 4.1 master and slave

    Hi, I'm curious about this. Is it still uncertain if the Slaev functionality was completed? I am trying to send data from a Teensy 4.1 as am I2C slave. Here is an image from a logic analyzer of what I am sending to it: And I am using the basic example (just modifying the slave address)...
  7. A

    Teensy 4.0 I2C Slave issue.

    Check this post: https://forum.pjrc.com/threads/57861-I2C-Slave-on-Teensy-4 And related library: https://github.com/Richard-Gemmell/teensy4_i2c/issues/21
  8. A

    SPISlave_T4

    Many thanks!
  9. A

    SPISlave_T4

    Hi! Thanks for the libary! I have two questions. 1. How would I go about to make the library work with an active-high setting for the CS? (That is, the CS will go high and then the clock signal will be sent, then CS goes low again). 2. I had a Teensy 4.1 working as a slave. I was trying to...
  10. A

    Teensy did not respond to a USB-based request to enter program mode.

    I also have this issue with Ubuntu Hi George, I also have this issue with Ubuntu. I am a bit confused, what do you mean with " the install bit with the 49 in it" and "You have to copy a file somewhere". Thanks
  11. A

    Bluetooth support for Teensy 4.1, hardware and software

    Hi all. I am working on a project with a Teensy 4.1 board and using a Mac computer. I am sending data with the serial cable at the moment using ( this library: MIDIUSB) to be able to send MIDI data. It works fine with the cable. I am looking forward to send the data wirelessly. I've looked for...
Back
Top