Search results

Hey thanks! I'll give it a try. -Andrew

Good day, I was working on a project that required the teensy 3.2 reset pad. Turns out this pad is like super fragile... and if fell off. I swear I barely touched it... :( Anyways, Is there another place on the teensy where I can tap the reset? Even if its a dirty hack I'm willing to give it a...

Hey Vjmuzik, Thanks again for the info! I was hoping I could find a simpler solution (even if it's quick and dirty) as things are already pretty cramped in my enclosure as it is and I need some space for cooling the CPU effectively. I don't care so much about accuracy but the problems is...

Good day, I am working with a motorized fader and have been trying to use to touchRead function as a way to interrupt the fader when it is in motion. I've been experiencing some odd (maybe) behaviour and although I have a work around I wanted to check if this is normal, if there is a problem...

thank you vjmuzik! I'll give this a try and report back with the results. -Andrew

Good day, I am working on a project that uses midi and requires 2 ports. Everything is tested and functional using the MIDIx4 profile for teensy. However, in this particular case the additional two ports are not used and may lead to confusion by the end user. Is there a straight forward way to...

So boneheaded mistake wins it! Actually I gotta give props to vjmuzik he hit the nail on the head with the first post. The pins on the connectors were flipped, not sure why it didn't work when I tested that last night but I was tired so I might have been making other mistakes at the same time...

And for the record I have some Vishay 6n138 and 6n137 optocouplers if anyone’s had better luck with the latter

It prints «*MIDI Input Test*» and then «*Inactivity*» every 10 seconds after as it should. I see no fault in the code as written. If it is a code related issue I would guess that it would be more something going on in the MIDI Library or with arduino/teensyduino not compiling properly, but I...

Thanks Larry, I have already tried slapping a resistor on pin 7 as described in the link, but when I get the chance I’m going to go through the data sheet again and try playing with the resistor values.

The answer is a finite supply of money, and I have built many projects including an analogue modular synth, DMX controllers, arduino and teensy based stuff, as well as wireless transmission projects without any need for a scope up to this point so please don’t patronize me.

I don’t have a scope... as I mentioned in the original post, I was kinda hoping to find some direction to trouble shoot this without dropping cash on test equipment as it would seem MIDI should be pretty straight forward at this point (being it’s a nearly 40yo protocol). Still I appreciate the...

I have already tried the connector wired in both possible configurations with no change in the result.

Hello, I am writing because I spent several hours today trying to get 5-pin MIDI to work with my Teensy 3.2, I followed the schematic located at the PJRC MIDI Library page precisely and am using the code provided for receiving MIDI messages on the same page and it simply does not work. I have...