Search results

  1. J

    Half of WS2811 LEDs not working?

    Well, I feel dumb. It turns out one of the test leads I was using to connect my power supply to the strips was disconnected within the clip's rubber jacket –*d'oh! Replaced it and now I have 8 LED strips rendering stuff out of TouchDesigner in perfect working order. Thanks for the quick help...
  2. J

    Half of WS2811 LEDs not working?

    Yeah, I understand. Here's the code I'm intending to use, adapting Lucas Morgan's TouchDesigner -> serial port system: // Lucas Morgan - www.enviral-design.com // #define USE_OCTOWS2811 #include<OctoWS2811.h> #include<FastLED.h> // ------------ Change these as neccesary -----------// #define...
  3. J

    Half of WS2811 LEDs not working?

    I did a project last year that had 8 LED strips fed by a Teensy 3.2 + OctoWS2811 shield beautifully. I am adapting the light fixtures for a new project now, and seem to have a problem where only half of the LEDs (strips 1-4) are driven at once from the OctoWS2811 shield (each set of 4 has its...
  4. J

    Half of WS2811 LEDs not working?

    I did a project last year that had 8 LED strips fed by a Teensy 3.2 + OctoWS2811 shield beautifully. I am adapting the light fixtures for a new project now, and seem to have a problem where only half of the LEDs (strips 1-4) are driven at once from the OctoWS2811 shield (each set of 4 has its...
Back
Top