Search results

  1. G

    Playing wav file in looping best way

    Check the code I wrote for looping raw files. You can take the existing wav file player and adapt accordingly. Just Rewind to the start of the sound data.
  2. G

    IRremote and Audio Adapter Board

    I will try. In the mean time, I replaced the timer interrupt setup: #define TIMER_CONFIG_NORMAL() ({ \ SIM_SCGC4 |= SIM_SCGC4_CMT; \ CMT_PPS = CMT_PPS_VAL; \ CMT_CGH1 = 1; \ CMT_CGL1 = 1; \ CMT_CMD1 = 0; \ CMT_CMD2 = 30; \ CMT_CMD3 = 0; \ CMT_CMD4 = 19; \ CMT_OC = 0; \...
  3. G

    IRremote and Audio Adapter Board

    I found Paul's version of the IRremote library for the Teensy (3.2 in my case) and it works fine. However, when I have the Audio Adapter board connected (and running), the codes received are all over the map. I haven't looked too far into it yet and I'm wondering if any one else is using the...
  4. G

    ESP8266 Add-On for Teensy 3.2

    defragster Ha! This is what I was looking for. I had pegged on a separate thread and found your link to this one. I'm fighting IRremote right now but I will come back to this once I'm done. For what's worth, I've been working on a same scenario for a completely different board (a flight...
  5. G

    Playing two (or more) RAW files

    Paul, Thanks for the quick response. It turned out to be the MicroSD card. I had one exactly like the one you suggested (an 8G SanDisk Ultra) and given that the tested seek times were within reason (around 800us), it didn't occur to me to test a different one. I found another, newer one (16G)...
  6. G

    OTA Updates using the ESP8266 and Teensy 3.2

    I have the exact same question. I've been programming the ESP8266 for the past couple of months and I have it to a point where it is quite stable at 1Mb UART speed. I wiped the existing firmware and wrote my own from scratch. I have a (completely unrelated to teensy) project that does just that...
  7. G

    Playing two (or more) RAW files

    I'm having a bit of a hard time playing more than one (raw) file at a time. Even using the Part_2_02_Mixers.ino tutorial code shows the same problem. Most of the time SD.open() fails or when it works, the sound is garbled. Playing one file at a time (one from each instance of the SD raw file...
Back
Top