Search results

  1. V

    Teensy 3.2 Arduino Shield + Lipo Battery

    Thanks for detailed explanation. I am using feather adapter, can’t see a pin for VCC. I see that in teensy, but do not want to use as that will defeat whole purpose. I have ordered new lipo just to isolate issue.
  2. V

    Teensy 3.2 Arduino Shield + Lipo Battery

    I am using prop shield as well. Have all teensy pins connected to featherwing, everything related to teensy+propshield works. NixonMotion sketch gives calibration data which means prop is well connected. Do I have to use any jumper?
  3. V

    Teensy 3.2 Arduino Shield + Lipo Battery

    I am trying the featherwing adapter, I see LED solid yellow near J socket so I am assuming power is going LiPo. However even after couple hours of this state, unplugging USB doesn’t switch power. I am using Teensy3.2 and sample blink program works. So I am quite sure Teensy is working. Do u...
  4. V

    Teensy 3.2 Arduino Shield + Lipo Battery

    Hello Everyone, I am currently using this shield from https://www.sparkfun.com/products/15716 and powering TEENSY 3.2 using external power. So far all good, however I also want to charge Lipo on this shield while external power is connected and switch to battery when needed. There is not much...
  5. V

    Teensy 4.1 Lockup

    Actually I am good now. All I have to do is click on board manager and change to Teensy 4.1, USB detecting doesn't mean board can be remapped automatically. I was using ESP earlier.
  6. V

    Teensy 4.1 Lockup

    I am having trouble as I can't see upload sketch, i get error Sketch uses 248972 bytes (23%) of program storage space. Maximum is 1044464 bytes. Global variables use 28144 bytes (34%) of dynamic memory, leaving 53776 bytes for local variables. Maximum is 81920 bytes. An error occurred while...
  7. V

    Teensy 3.2 on Prop Shield

    Thanks MichaelMeissner, this definitely helped as made it clear exact reason for these pins on side. I used female socket on Prop Shield so that I can take Teensy out and plug into Generic Shield, it worked like charm! At the moment I am not using Audio as I wanted a good alternative of MX2125...
  8. V

    Teensy 3.2 on Prop Shield

    I am attaching picture and interested in motion sensors. Should I supply +5V, GND aafter soldering 5 pins?
  9. V

    Teensy 3.2 on Prop Shield

    Hi, Halfway thru the page at http://www.pjrc.com/store/prop_shield.html which is basically "Audio Amplifier" section, I see that teensy is dropped into a socket soldered to prop shield. I got prop shield without pin, so presumbly I can plug teensy and get that to work. Unfortunately, this is...
Back
Top