Search results

  1. T

    Three Stepper Motor control

    Hi Mark, Thanks for the suggestion. I have also assumed it might be a good source for some code. Right now I haven't been able to figure out the Teensy4.1 enough. I believe I have firmware downloaded. Just too novice to get anywhere as nothing makes sense to me. I don't understand code anyway...
  2. T

    Three Stepper Motor control

    Hi Everyone, I have a project that uses three stepper motors with with 542 drivers. I have looked at numerous web sites and github pages, but I am so novice that I just don't get it. My goal is to give the Teensy a set of values derived from a chart and have the steppers independently turn a...
  3. T

    grblHAL on a Teensy 4.1

    Hi Phil, Thanks for the reply. I guess, i am going to try something else. I need to figure out how to park three stepper motors at three different predetermined locations/coordinates. These location values are found in a spread sheet using a numerical input and a condition input. I was also...
  4. T

    grblHAL on a Teensy 4.1

    I see this an old thread and hopefully this question is appropriate. I am very novice to the whole Teensy and arduino capabilities and I possess none of the coding expertise. I want to run three steppers that are not configured in a true three axis configuration. They will be feeding three...
Back
Top