Search results
-
F
SPISlave_T4
Could you guide me a bit about where could I change that? Is it too complicated to do? Maybe I can try to change it.- fabianG
- Post #19
- Forum: Project Guidance
-
F
SPISlave_T4
Yes they are connected. I was checking the voltages, and the MISO port from the PIC32 is always HIGH and goes down and back again when there is data available. In the Teensy4, the pin is always LOW and when there is data it goes up and down. Could this be the problem? Since the "default"...- fabianG
- Post #17
- Forum: Project Guidance
-
F
SPISlave_T4
Hi, I am currently using this library to communicate via SPI with an openBCI. The openBCI uses a pic32 as the master that controls SD card, analog to digital converter and a RF module. I would like to add to this board a teensy so I can add more features to the board. Currently I am trying to...- fabianG
- Post #15
- Forum: Project Guidance