Search results

Thank you so much for your reply. You've confirmed my decision.

Thank you for the fast reply Paul. I believe your answer meant that you still didn't test Quad audio on the Teensy 3.6 along with 2 Audio shields correct? I guess I wasn't clear about the question, I apologize for that. My question is, can I disregard the Audio sheilds all together and have the...

Hello guys, I posted before about Teensy 3.2 and Audio shields and I'm pretty much a pro at them now. It is quiet a hassle to connect the Teensy to two Audio shields (needed for 4 analog input, 2 analog output). I was thinking would it be possible to have all the processing done on the Teensy...

Hello guys, I am very fascinated by the ease of use and power of Teensy so I am working on miniturizing the board for one of the projects and still using the same arduino interface and libraries. I got the board to miniturize but the processor is too big (8 mm x 8 mm) for my earphones...

Hey guys, thank you so much for the great input. All I had to do was enable the "Pre-Processor" and adjust the incoming signal before mixing the channels. Just to spread the tips of using this amazing Audio shield, here is a work around that I did in case the solution above doesn't work for your...

Hi guys, I've been using the Teensy 3.2 along with two Audio shields, following the Quad tutorial shown below: https://www.sparkfun.com/news/2055 So now I have 2xLineIn, 2xLineOut/headphone. I am trying to apply an Eqalizer for each Line In and output all 4 channels in one Line out. The...