Search results

Hello ledcolor, It looks to me that is yet another version of a WS281x, I've found several products advertised under different chip numbers but perform the same (or almost) like the APA106 leds, they are basically a WS2812. Have you tried hooking them up and program them as if they were WS281x...

I forgot to mention... I did use the RESET pad, just ran a wire from GND to the pad, held it down together with the program button, waited for the loader to fail to find Teensy, then plugged Teensy to the USB port and released both the reset pad and the program button. I waited for Windows to...

Hello respector, I've been designing with PICs for many years now, altough they are awesome products (most of them) they have very short legs... I managed to make it work but the processor becomes too busy to do anything serious with it, the WS281x strips require very precise timing and the...

Hello th8a. I just brought it back o life, it turned out to be the contact on the RESET pad that was not ideal... I followed this thread: https://forum.pjrc.com/threads/31518-Can-t-communicate-with-Teensy-3-2-through-Teensyduino?p=88073&viewfull=1#post88073. That actually fixed it after a...

Hello th8a. Same here but with a 3.1 version also USB powered. The loader froze while in the "erasing" step. After that the board is not recognized by the computer (tried with 3 different PCs ). I tried all the troubleshooting steps listed in the help files and forums, with no luck. All voltages...