Search results

  1. A

    Teensy 3.0 attaching micro SD adapter

    I have looked at that, but the adapter is never mentioned if it can easily solder directly on top of the Teensy 3 board.
  2. A

    Teensy 3.0 attaching micro SD adapter

    Has anyone cleanly connected PJRC's micro SD adapter to a Teensy 3.0? Here are my thoughts so far. The pads on the back of the SD adapter have to be soldered together since the Teensy 3.0 is operating at 3.3 V. One pinout on the adapter will go to a 3.3V power supply, which will be pin 3.3V...
  3. A

    Teensy 3.0 LiPo Battery Connector

    Hi, I am looking at placing a JST LiPo battery connector ( https://www.sparkfun.com/products/9749 ) on my Teensy 3.0. From this schematic ( http://www.pjrc.com/teensy/pinout.html ) I assume I would place it on Vin and AGND. Then would I be able to slide the SD adapter down and use jumpers to...
  4. A

    Flash Memory in Teensy 3.0

    I was looking at getting Teensy 3.0 and was wondering if it is possible to collect data through one of the digital/analog pins(or whatever) and store that data to the flash memory and if that would be accessible when plugging it in to a computer as a flash drive would. More looking how a...
Back
Top