Search results

Hello, I have the following problem. When I connected it incorrectly, my Tensor 4.1 board stopped working (it actually burned out). I noticed that it was getting very hot in a certain area and to localize it, I put a small amount of flux on the elements that were in the area that was getting...

It shows no signs of life, just heats up :cry:

Hello, I apologize in advance for the stupid question., but I mistakenly applied 5 volts instead of 3.3V to pin 14 on a teensy 4.1. Can you point me to a possible resurrection of the board or should I go for the option of ordering a new one?