Search results

Yes, it is, flux plus a drop of solder. As soon as I have isopropil I will clean and remove solder, but it doesn't seem to short anything...would it?

I know it is very probable. A replacement board is arriving, however, just to be sure, I would like to measure the tension out of the regulator: which pin(s) should I measure? (regulator is U4 right?) Then I will also double check solderings in the thermocam PCB. I would also discover the cause...

Thank you for the advice. Here are the pictures:

Here some pictures: https://photos.app.goo.gl/1RERkPQyYTpcR82V7

Hi everybody. I am an absolute newbie in electronics. I have a Teensy 4.1 used in this project: https://www.diy-thermocam.net/building-instructions/. I followed the instructions step by step, but since it's my first time using a soldering iron, I must have made some mistakes. Once arrived at...