Hello world,
I'm using a Teensy 2++ and put several buttons and encoders on it. What I noticed,
is that when correctly connecting the encoder (code is checked by Dozer) I sometimes
get wrong values. I thought of a debouncing problem, but then I put clean 5V signals
using another Atmel-based board on the Teensy - the problem still persists.
I am clueless on this one, Paul - do you have any idea?
Thanks,
Olli
I'm using a Teensy 2++ and put several buttons and encoders on it. What I noticed,
is that when correctly connecting the encoder (code is checked by Dozer) I sometimes
get wrong values. I thought of a debouncing problem, but then I put clean 5V signals
using another Atmel-based board on the Teensy - the problem still persists.
I am clueless on this one, Paul - do you have any idea?
Thanks,
Olli