Hi,
i'm using the small Teensy 2.0 and am not able to enable the INT6 (PE6). Reading works properly but interrupt is not fired. This pin is 10k pulled up and i tried to attach a falling signal interrupt - no luck :-(
Reading the Pin works properly but polling is'n very cool - some keystroke will be lost... :-/
Config: Arduino 1.0.2, current Tennsyduino
any suggestion?
Michael
i'm using the small Teensy 2.0 and am not able to enable the INT6 (PE6). Reading works properly but interrupt is not fired. This pin is 10k pulled up and i tried to attach a falling signal interrupt - no luck :-(
Reading the Pin works properly but polling is'n very cool - some keystroke will be lost... :-/
Config: Arduino 1.0.2, current Tennsyduino
any suggestion?
Michael