brianmichalk
Active member
I have upgraded to the 4.0 due to the non-availability of the beloved 3.2. In doing so, I erroneously mapped to the USB pins on the back side, because I have a USB hub module and some cameras on my circuit board. So, I plug it in and discover it's USB host, not device.
I looked at the T36 USB library, and don't see anything, but I'm wondering if there is a way to configure the OTG USB to be a device? This would be for UART messages to the host computer. I.e., I would like it to show up as ttyACM0 or ttyUSB0 on my computer.
I looked at the T36 USB library, and don't see anything, but I'm wondering if there is a way to configure the OTG USB to be a device? This would be for UART messages to the host computer. I.e., I would like it to show up as ttyACM0 or ttyUSB0 on my computer.