XPICO WIFI DEVELOPMENT BOARD

R

Roboy

New member
I'm new to this forum and I just received a Lantronix Xpico WIFI development board.

I have tried to connect to the Xpico WiFi by using Device Installer ver 4.4.07.
Unfortunately, the Device Installer cannot find it.
Does the Device Installer software require any specific settings or configurations to detect WiFi devices?

My PC can be either wifi or CAT5 (wired). When wired it's connected to a Netgear Hub and then to a Wifi/Wired router via a CAT5 cable.
When it is WiFi or wired the Device Installer can't find it.

The board has a CAT5 socket, but it is not active when the XPW1001000-01 wifi module is installed on the board.

So my question is does the Device installer detect WiFi devices?

I've used it before to detect Xports without any problems, but never tried WiFi until now.

Thanks for any advice.
 
@Roboy: Which specific Teensy processor are you connecting this device to ?? How (by what physical means) are you making that connection ? This forum is for users of the Teensy family of processors & accessories. It's not obvious from your post that you are using your device with a Teensy. If, instead, you are attempting to use it in some different way, your question might be more appropriately posted on a different forum, etc.

Mark J Culross
KD5RXT
 
Maybe you should contact Grid Connect for support?

Their website says this:

1736469540892.png
 
You must log in or register to reply here.
Back
Top