Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • loglow's Avatar
    Yesterday, 07:59 PM
    Just sent you guys private messages to follow up about this.
    43 replies | 2106 view(s)
  • loglow's Avatar
    08-16-2019, 11:51 PM
    If I were to make a few pre-release breakout boards, are there some folks who'd be interested in putting the USB host port through some rigorous testing? Shipped out free, of course. Let me know and we can work out the...
    43 replies | 2106 view(s)
  • loglow's Avatar
    08-14-2019, 09:24 AM
    Some updates: Added SD card bypass cap pads, moved SD socket a little. Removed redundant 3V3 and GND pads from Teensy footprint. Added ON button pads, moved VUSB-VIN switch a little.
    43 replies | 2106 view(s)
  • loglow's Avatar
    08-10-2019, 06:03 AM
    Based on the feedback already received, you can see a revised pin layout on the breakout image below. VHST would be the output from a TPD3S014. Not entirely sure how I'll handle this as a kit yet though. Here...
    43 replies | 2106 view(s)
  • loglow's Avatar
    08-08-2019, 06:58 PM
    Soldering a 1 mm pitch flex cable should be ok. I think. I'm excited to try, at least. The cost isn't too bad. It's looking like roughly $0.50 per flex board. The connectors are comparable to that. I'm trying to use...
    43 replies | 2106 view(s)
  • loglow's Avatar
    08-08-2019, 06:49 PM
    I think this is totally reasonable, and I'll probably make this change for these reasons. Good catch. Not a huge deal, but there's an easy solution: I'll move ON and PG over to the same side and have 28 and 29...
    43 replies | 2106 view(s)
  • loglow's Avatar
    08-08-2019, 06:41 PM
    Are you talking about the D+, D-, etc. pins in the lower-left of the top image? I could see about rearranging these to match the 5-pin order. Since there are several extra GNDs, there's room for it. Just for reference,...
    43 replies | 2106 view(s)
  • loglow's Avatar
    08-08-2019, 06:43 AM
    Hi, Congrats on the Teensy 4.0 release! I'm working on a breakout kit for this, and I'd love to get some feedback before producing the first run. Here's what I've got so far:
    43 replies | 2106 view(s)
No More Results
About loglow

Basic Information

Statistics


Total Posts
Total Posts
96
Posts Per Day
0.04
Last Post
Teensy 4.0 Breakout Kit Yesterday 07:59 PM
General Information
Last Activity
Yesterday 07:59 PM
Join Date
01-28-2013