Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • Donziboy2's Avatar
    03-23-2018, 12:11 PM
    Here is an updated basic schematic. There are Op-amps on the market that are rated for 36V continuous, that would be plenty for an 8S pack in case you want to future proof. As a BMS this is probably not the perfect...
    11 replies | 514 view(s)
  • Donziboy2's Avatar
    03-23-2018, 10:27 AM
    Correct as a battery monitor the circuit I provided would unbalance the pack. For the High accuracy resistance measurements it would be very good. Some of the uneven discharge could be adjusted by changing the resistor...
    11 replies | 514 view(s)
  • Donziboy2's Avatar
    03-22-2018, 05:26 PM
    No reason why this should not work. Just hook it up to an ADC and your done. This could be done with the test board I created since I set up the dividers to be changeable between different configurations. Just...
    11 replies | 514 view(s)
  • Donziboy2's Avatar
    03-19-2018, 10:08 PM
    Or 16bit single ended ADC with all channels scaled to 27-30V will give you sub mV readings. It really depends on cost. I have an 8 channel 16-18 bit 400kSPS ADC breakout for the ADS8698 series. Depending on what chip...
    11 replies | 514 view(s)
  • Donziboy2's Avatar
    03-19-2018, 12:29 PM
    1. No real practical way of doing this unless you went to invest in a large array of relays with an isolated supply to power the Teensy. 2. Unless you invest in high accuracy resistors your going to be stuck with...
    11 replies | 514 view(s)
  • Donziboy2's Avatar
    02-27-2018, 09:26 PM
    Been pretty quite the last few months on this, work has been keeping me extremely busy along with life in general. I significantly reworked the design a few weeks back and added Isolation between the analog and...
    93 replies | 25282 view(s)
  • Donziboy2's Avatar
    02-22-2018, 10:46 AM
    Interesting. Whats the output load on the Murata 78SR and what does your input voltage look like at start up? We use the 78SR's at work and I also use them at home. They are very handy and fairly clean even without...
    23 replies | 608 view(s)
  • Donziboy2's Avatar
    02-22-2018, 10:21 AM
    Running 12 hours days at work right now so cant give actual code pieces but. You did not change the number of samples per reading you are doing so by default 4 samples are taken per value output. Your buffer is really...
    9 replies | 424 view(s)
No More Results
About Donziboy2

Basic Information

Statistics


Total Posts
Total Posts
636
Posts Per Day
0.34
Last Post
Battery Monitor Question 03-23-2018 12:11 PM
General Information
Last Activity
Today 11:05 AM
Join Date
03-14-2013