jmarsh,
Thx. That would work although I'd also like to change the output state during the runtime code, not the setup() section.
Can pinMode() statements be used in the main loop() section?
I have a Teensy 2.0 I am using on a project and am using a few digital pins which I would like to program to one of three states depending on mode: Low, High, or Hi-Z.
By Hi-Z, I mean high impedance (or open).
Does the Teensy 2.0 support hi-Z...
A newbie question.
I am writing a basic routine to control a stepper driver chip using my Teensy 2.0.
I have several outputs which I want to initialize to a specific value (High or Low)
just once at the beginning of my routine. I don't want to...