Regarding a pull request: I am not sure how to proceed. I changed a lot compared to the original code like the update to the usb2 specification. Unfortunatley it is not possible for me to test it with many different hosts and it would therefore...
Glad you got it working. :)
Be careful about Teensy's power pins accidentally touching the metal chassis of your laptop. In theory everything should have over-current protection. In practice, best not to put that to the test.
Hi Paul, thank you very much for the reply. I was able to give it a good cleaning with the available resources I had at hand. Never knew an orange light can give me so much joy ! Back to the tutorials now
I'm not sure I understand your issue but the delay(1000) will probably not work too well.
Try this example non-blocking loop().
// IntervalTimer myTimer; // NOT IN USE HERE
const byte interruptPin = 2; //button
volatile unsigned long blinkCount...
WoW :D
I've been using your asynchronous spdif input successful and now you bring us hope for USB 8ch.
Alex thanks for this wish I have time to test this out now.
I've done a PR to your repo, having done a bit more testing - this essentially adds in stuff I'd already done previously. Minor change to your code to make it compile with 8 channels @ 96kHz. Haven't time for more right now, but will be back!
Sure, I expressed myself unclearly. I was just thinking about how we could prepare the code so that there is the chance that Paul accepts a pull request.
I have to admit, I have never used the Design Tool, but I would give it a try and test the...
I tested you suggestion:
There is now the variable 'async' in line 789 in usb_audio.cpp. (I will change that later, but for now for some quick tests it should be fine). If async is set to false, the usb audio output sends always the expect number...
Here you go! The dangly bit at the right is the DC-DC converter, and the DuPont cabling is connecting two differential outputs back to inputs for testing.
I have no idea on C50 and C52, I cribbed them straight from “Figure 60. Buffer and...
Given that many of you request USB-C, I found this U-Tube video describing the USB-C standard and it's use and detection.
If you use USB-C at all it's an interesting watch/listen. It includes data on what is or is not a good USB-C cable.
I found an issue with inverted serial and half duplex mode where the current serial setup configures the pin for pull-up which causes an issue when you change the TX pin to RX by TXDIR bit in LPUART ctrl register. Using the sketch below and...