Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
BJB's Activity
About Me
Tab Content
  • BJB's Avatar
    07-12-2019, 03:20 PM
    BJB replied to a thread Designing a pcb ? in General Discussion
    You cannot purchase Eagle. A basic subscription costs approximately $100 USD per year. Plus whatever portion of your soul you are selling to the 'cloud'. Have not used Eagle for several years because its autorouter...
    11 replies | 381 view(s)
  • BJB's Avatar
    07-12-2019, 02:31 PM
    Did something similar using a high-freq version of NFC (manchester NRZ). Totem-poled transistors (push-pull config) used to directly drive the tank circuit to the antenna. So you will have to roll your own on this,...
    5 replies | 114 view(s)
  • BJB's Avatar
    05-30-2019, 12:02 AM
    Have never been a big fan of these current sensors, but they are functional for simple stuff. The 'best' design practice would probably be to leave the fault pin open and connect the 'ground' stuff to the Teensy...
    15 replies | 2942 view(s)
  • BJB's Avatar
    05-29-2019, 03:43 PM
    Concur with XFer and brtaylor. Based on several HALT series done with Teensy 3.2s, do not recommend use in industrial control products where internal ambient is under -20C. As 'industrial' grade stuff is typically...
    6 replies | 321 view(s)
No More Results

Statistics


Total Posts
Total Posts
145
Posts Per Day
0.07
Last Post
Designing a pcb ? 07-12-2019 03:20 PM
General Information
Last Activity
07-12-2019 03:21 PM
Join Date
01-30-2014