Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • FAlameda's Avatar
    Yesterday, 06:38 AM
    Many thanks. I will study and try these ideas. I thought that this would be a more widespread problem and that someone would have developed a ready-to-use Tindie breakout board.
    6 replies | 106 view(s)
  • FAlameda's Avatar
    10-17-2018, 12:09 PM
    Yes, I was studying those schematics but there are several problems. They are unidirectional, they only isolate the Midi input. We must assume that the Midi device at the other end has its own opto-insulated input. ...
    6 replies | 106 view(s)
  • FAlameda's Avatar
    10-17-2018, 09:19 AM
    Hi all, I'm planning to interface a Teensy 3.5 system to a RAMPS 3D printer type motion driver. The motion system uses a 5V Arduino with a 5 Volt Serial TX/RX communication port. As the two systems are going to...
    6 replies | 106 view(s)
No More Results
About FAlameda

Basic Information

Statistics


Total Posts
Total Posts
30
Posts Per Day
0.02
Last Post
Opto Isolated Serial Yesterday 06:38 AM
General Information
Last Activity
Yesterday 06:38 AM
Join Date
02-10-2014