BriComp
Senior Member

The Nextion web site states that the I/O adaptor puts out 5v. The T4 only supports 3.3v devices. You may have "blown up" that input on the Teensy.

There are 4 channel and two channel versions look for TSX0104 and TSX0102.

Why not use a 40 pin IDC cable/socket/plug wired as shown below. This will result in every other wire being gnd. Also makes it easy making the cable using DIL IDC plugs and sockets.

Oops sorry, I see that Oak Tree LLC is selling through Amazon, but check the prices I think you will see that it is buyer that is being shafted. Prices for a T3.2 and LC are:- ...

I said UK distributors. Amazon is not a PJRC distributor. UK distributors are:- Cool Components, HobbyTronics, Oak Tree LLC, PiHut and Pimoroni. They are listed here.

Even by using an extended partition which can hold other partitions, I still believe that the total number of partitions on an MBR formatted drive is 4. A GPT partition can be formatted with up to 128 drives.

Windows only allows a maximum of 4 partitions per drive.

It is possible but shipping charges are silly. Not Paul's fault but USPS. Better to buy from Paul's UK distributors.

Yes, 18 pins for 8 lanes instead of 20 pins, but also cheaper.

...or you could use something like a TSX080E, like this. Plenty of current to drive the opto-isolators and relatively cheap.

If speed is not paramount you could consider a PCF8574 I2C 8 bit expansion chip. The current per pin is 25ma with a total of 100ma for the package. There are also 16bit versions viz MCP23017. This latter chip being...

Your data on using Serial.begin on this page https://www.pjrc.com/teensy/td_serial.html states that:- "Serial.begin() Initialize the Serial object. The baud rate is ignored and communication always occurs at full...

A possible solution could be to enlarge Serial.begin() to Serial.begin(baudRate, timeOut or delay) where Serial.begin(baudRate) /Serial.begin() defaults to a timeout/delay of 2.5 seconds, or whatever is determined to be...

Could it be a timing issue, Teensy 4.x going much faster? In order to rule out, compile for a much lower speed similar to Teensy 3.x.

You could consider one of these. It provides 5v (and 3.3v) for the Teensy. It is powered from a usb psu. You could solder a wire to the battery connection and shut down and save data to sd card, or whatever, when...

Hi Frank, If you would wish to share the cost of the board I would welcome to join in.

Here is another display. Has HDMI and VGA inputs complete with i/o board.

This display might be useful when used with the above suggestion.

since you are looking for battery power this might be of interest. Provides battery charging facilities as well. Very cheap - about $3 if I remember correctly. EDIT: You can get them here.

Hi Duff, hope you and your family are well. I have posted a sample prog which demonstrates the problem under "suggestions and .....".

Both sleep and deepSleep fail. Have not tried hibernate as it does a reset each time which is not useful.

I have confirmed that the Snooze Library Kills the EEProm library. Have raised the issue in "Suggestions and Bug Reports"

Hi, I don't claim to re any sort of expert but I see a number of possible problems. You have setup snooze to use digital and alarm - you have not used any digital input to wake up, so take the digital out from the...

He is trying to experiment with NOISE CANCELLING. Broadcasting an inverted signal in an attempt to cancel out ambient noise. Due to the inevitable processing delay, will not work by playing output through a speaker to...

Just thought I would add a different graph of your (JotaEfe13) data.

Are you going to be selling them? I would be interested.