Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • kito's Avatar
    08-24-2019, 01:10 AM
    kito replied to a thread Encoder with X Plane in Project Guidance
    The encoder returns integers so the 1st issue your not going to get floating point. To debug I would print the TempSel.read(); every time it changes and print the read values without subtracting to see what the values...
    6 replies | 136 view(s)
  • kito's Avatar
    08-23-2019, 12:33 AM
    I figured u guys could get a good laugh at my expert soldering skills and my total commitment to cleaning flux of my board.
    44 replies | 1098 view(s)
  • kito's Avatar
    08-22-2019, 08:02 PM
    @mjs513 your script work on my setup too. Thanks. I debugged you code vs my example and it seems the baud rate was the issue. The baud rate should be AFTER the begin() method. I tried setting the baud rate...
    44 replies | 1098 view(s)
  • kito's Avatar
    08-22-2019, 02:43 AM
    Ok, so I just toggled pin22 in a loop to create a 1.1mhz clock on (CTX1) high and low using digital write in a loop. I see it go high and low, I also see RX path going high and low back on pin 23. I also see the same...
    44 replies | 1098 view(s)
  • kito's Avatar
    08-22-2019, 02:21 AM
    I'm using two IFX1050GVIO chips. I have it on bread board with just bread board wires. I currently do not see any data coming out of teensy TX pin so I'm not sure if it matters to see the mass ball of wires. I mean...
    44 replies | 1098 view(s)
  • kito's Avatar
    08-22-2019, 01:58 AM
    Thanks Your right it switched the board type after install. Ok it compiles fine now but same result. I scope to tx and rx pins at both CAN1 and CAN2 and they a driving static hi level while the loop is going. (pins...
    44 replies | 1098 view(s)
  • kito's Avatar
    08-22-2019, 01:33 AM
    Hi, I downgraded to 1.47 beta5. I was on release. I started on release and cloned the FlexCAN_T4 repo so I dunno if this is related. Anyways, I get an error during compile for beta5:...
    44 replies | 1098 view(s)
  • kito's Avatar
    08-22-2019, 12:50 AM
    Hi, Thanks for responging. >Can you try that test on 1.47beta5 teensyduino? Ok will try it out. >do you have resistor 120 ohm on the line? yes have two IFX1050GVIO transievers hooked together. With 120oh...
    44 replies | 1098 view(s)
  • kito's Avatar
    08-21-2019, 10:36 PM
    Hi, Is it possible to include a simple test example for this? I tried to use the example from existing FlexCan but I see no read data. So I found during debug there is no output on the TX pin its stuck high- I see...
    44 replies | 1098 view(s)
No More Results
About kito

Basic Information

Statistics


Total Posts
Total Posts
28
Posts Per Day
0.01
Last Post
Encoder with X Plane 08-24-2019 01:10 AM
General Information
Last Activity
08-24-2019 01:10 AM
Join Date
07-02-2014