Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • tsgwiro1's Avatar
    02-16-2019, 07:54 AM
    Had a chance to scope the supply and the voltage ramps up from 0V to 4V in about 20ms (on the Rigol DP832). It seams that is to slow for the Teensy to start properly.
    8 replies | 183 view(s)
  • tsgwiro1's Avatar
    02-10-2019, 12:18 PM
    I'm pretty sure I did. Beside the SD slot there are 5 pads. Soldered the capacitor between the middle pad (gnd) and the bottom one (RST) with the sd slot pointing to the left. On the bottem side of the Teensy they are...
    8 replies | 183 view(s)
  • tsgwiro1's Avatar
    02-10-2019, 12:10 PM
    I tried that. Added all sorts of values 1n, 10n, 100n... unfortunately no luck.
    8 replies | 183 view(s)
  • tsgwiro1's Avatar
    02-10-2019, 11:34 AM
    I have connected the GND to all the GND Pins (analog and digital) they are all connected together, might that be a problem? The power supply is fine and the connections are sound.
    8 replies | 183 view(s)
  • tsgwiro1's Avatar
    02-09-2019, 02:14 PM
    Hi I want to power the Teensy 3.6 via Vin Pin through my Rigol DP832 with 5V, the trace to USB power is cut. If I connect the Teensy and turn the Power Supply output on, the Teensy does not start. If I remove the...
    8 replies | 183 view(s)
No More Results
About tsgwiro1

Basic Information

Statistics


Total Posts
Total Posts
10
Posts Per Day
0.01
Last Post
Teensy 3.6 power-up issues 02-16-2019 07:54 AM
General Information
Last Activity
02-16-2019 07:54 AM
Join Date
07-11-2014