Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • Wayne's Avatar
    05-15-2019, 08:45 PM
    Live and Learn.. You can if you do not place a pulseIn(xxxx,HIGH) right after pulseIn(xxxx,LOW) Also, I know the code repeats at 75ms. So when I get a value over 74000 I should start my reads. I however loose the 1st...
    10 replies | 556 view(s)
  • Wayne's Avatar
    05-14-2019, 05:41 PM
    I'm back.. Now since this is working.. I need to make a test fixture. (Machines cost $$$).. This is a Manchester code.. So here is the original scope image of a NOKEY condition (no buttons pressed) NOKEY ...
    10 replies | 556 view(s)
  • Wayne's Avatar
    05-06-2019, 07:57 PM
    This is amazing.. I have yet to have any bad loader chips when used in pre-production boards that I soldered components on. I have done a few.. over 25 if I recall. The only issue that the schematic software that I...
    73 replies | 1405 view(s)
  • Wayne's Avatar
    04-03-2019, 02:19 PM
    Success... Works really good. Did lower the >1000 to >300 and works great. Thanks a bunch.. If -Then are good. I did use Switch Case on another project of which PJRC ends up selling a few bootloaders once in...
    6 replies | 152 view(s)
  • Wayne's Avatar
    04-02-2019, 07:26 PM
    Wow, never did I think of switch case. I'm going to give this a go.. This is a great help. Note: don't type and hiccup at the same time.. Does not work well when typing..
    6 replies | 152 view(s)
  • Wayne's Avatar
    04-02-2019, 05:14 PM
    Code: Not at all clean... unsigned long time_now = 0; unsigned long time_now2 = 0; int LED = 25; int LED2 = 26; int SW = 23; int SWwasLO = 0;
    6 replies | 152 view(s)
  • Wayne's Avatar
    04-02-2019, 05:10 PM
    Yup, if I do it pass a few seconds or before the timeout of 9 secs, the Engage relay pops on and off.. quick but it could cause an issue.. If I do it within a sec or a little more it does not engage the Engage relay..
    6 replies | 152 view(s)
  • Wayne's Avatar
    04-02-2019, 04:17 PM
    I'm trying to use millis() in this setup and have an issue.. Here is the info: The conditions: (one pedal) Press pedal once activates the ARM relay. If pedal is not pressed in 9 secs drop ARM relay. If pedal is...
    6 replies | 152 view(s)
No More Results
About Wayne

Basic Information

Statistics


Total Posts
Total Posts
162
Posts Per Day
0.10
Last Post
Creating pulse 5us width 05-15-2019 08:45 PM
General Information
Last Activity
05-16-2019 04:50 PM
Join Date
10-29-2014