DaQue
Senior Member

I personally wouldn’t mind if it got a 0.1” wider. It’s not like I plug them into actual IC sockets. It probably would make routing a whole lot easier. That would eliminate 3.5/3.6 pin location matching so you could go...

@FRDM4236 I’m curios and if you don’t mind what issues or concerns caused you to break the headers into multiple pieces?

I took a soldering class years ago as part of ongoing training related to ISO9000 for a former employer and the trainer didn't fully trust no/non-clean flux. His issue was that its only promised to be inert once its...

Thanks for a quick answer. I was looking for a V2 link is what my self inflected issue was so I ignored the V3 linked page. The bump out on the side for extra USB support was not something I was interested in and at ...

Why not a link to either your OSHPark shared boards or directly to this one. It was a bit hard to find. Or at least one on WWW.trainer4edu.com. 3 of the one without the bump out for USB host on the way to me now.

But any 1070 based item would also likely have a lot tacked onto it to leach power.

You’re right bigger regulator is more a 4.01 hope. My bad

I’m confused still after reading most of the linked thread. The top half of ram is usable for stuff like larger arrays if logged data?

How about a beefier or 2nd controllable 3.3 voltage regulator?

ADC’s ? How about a DAC or two? Only thing I see missing from the 4. Or maybe some of those spots like for external memory on the audio sheild . I am also a bit worried if the 4is overclocked there might not be a lot...

Thanks for posting over clocking currents. That’s quite a big jump at 816 MHz. I finally found my 4.0’s in a box under the bed(?!) so I can start trying afew things.

Two things. One this thread should be stickied so it’s at the top of announcements. The other is just a question or two. How much current is the Teensy 4 pulling at max overclock with the benchmark. Ali’s is it...