Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • DerekR's Avatar
    01-03-2020, 01:20 AM
    @Fritz A few of us tried using the WM8731 with the T3.6 and found a whole lotta problems with the I2C communication. The link to the thread is I2C problems with Teensy 3.6 and WM8731 codec. Paul ultimately found the...
    13 replies | 465 view(s)
  • DerekR's Avatar
    01-01-2020, 04:14 PM
    A bit off topic but if you are want to improve your soldering skills, here's a video showing the SMD assembly of a new Russian SDR (software defined radio) kit. It's not a tutorial, but it shows all the SMD soldering...
    407 replies | 27347 view(s)
  • DerekR's Avatar
    01-01-2020, 01:16 PM
    @ETMoody3 Are you going to use solder paste and just apply it without a mask, letting surface tension draw the paste off the solder mask? I've seen videos of this being done and it seemed to work well. I'm thinking...
    407 replies | 27347 view(s)
  • DerekR's Avatar
    12-31-2019, 11:33 PM
    @loglow, Will you be selling spare flex-cables when the kit is released? That would make it a lot easier to replace a wonky T4 on the breakout. I know it's possible to carefully remove and replace a flex-cable (I've...
    407 replies | 27347 view(s)
  • DerekR's Avatar
    12-29-2019, 01:06 PM
    @loglow - Dan, I think these are great decisions for the board assembly options. I'm sure a lot of people would be intiminated by the SMD assembly requirement. And talking of SMD soldering, there are many You Tube...
    407 replies | 27347 view(s)
No More Results
About DerekR

Basic Information

Statistics


Total Posts
Total Posts
245
Posts Per Day
0.18
Last Post
Using the I2S with Teensy4.0 01-03-2020 01:20 AM
General Information
Last Activity
02-25-2020 02:49 AM
Join Date
05-24-2016