Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • tonton81's Avatar
    Yesterday, 04:55 PM
    tonton81 replied to a thread SPISlave_T4 in Project Guidance
    yup you are correct the tdie bit on the 1062 is used because there was an issue using the rdie. i dont remember what but it took a long time to work out the kinks and qwirks just to get it stable (and functional) (try...
    94 replies | 8645 view(s)
  • tonton81's Avatar
    11-07-2022, 08:26 PM
    try enabling the interrupt at the end. whenever you set a MB the filters and interrupts reset.
    1119 replies | 195461 view(s)
  • tonton81's Avatar
    11-07-2022, 07:55 PM
    you already posted this as an issue on github. Don't set a filter then configure the mailbox. That is backwards. also post what mailboxStatus() shows
    1119 replies | 195461 view(s)
  • tonton81's Avatar
    10-26-2022, 02:35 PM
    just load master on one and slave on the other, if you dont see communication try swapping the MISO/MOSI lines around
    1968 replies | 292473 view(s)
  • tonton81's Avatar
    10-25-2022, 11:43 PM
    make sure Teensy 4.1 is selected in arduino if not already done for that error also do not use the GND pin located next to pin 0, you need to have both 4.1s connected with the GND pin located next to the 3.3v/5v pin....
    1968 replies | 292473 view(s)
No More Results
About tonton81

Basic Information

About tonton81
Seriously? ;)
Montreal, Canada
computers, micros, telecoms, gate systems, access systems, security systems, cars


Total Posts
Total Posts
Posts Per Day
Last Post
SPISlave_T4 Yesterday 04:55 PM
General Information
Last Activity
Yesterday 05:09 PM
Join Date