Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • jim lee's Avatar
    Today, 08:14 AM
    jim lee replied to a thread Teensy 2.0? in General Discussion
    Thanks for the spect, that'll help a lot. ! I was mostly wondering if it programmed just like "everything else". -jim lee
    8 replies | 99 view(s)
  • jim lee's Avatar
    Today, 08:05 AM
    jim lee replied to a thread Teensy 2.0? in General Discussion
    I already use 3.2s like jellybeans. I just liked the 2.0 because is was a little bit smaller and about $4 cheaper. I figured it may be good for putting it into things that didn't need a lot of processor power. -jim...
    8 replies | 99 view(s)
  • jim lee's Avatar
    Yesterday, 04:45 AM
    jim lee started a thread Teensy 2.0? in General Discussion
    I just ran across the Teensy 2.0 I actually like the look of the thing (Its tiny) for using as a controller. Is it like all the other Teensy, Feather & Arduino things that I can run Arduino code on? Specs? ...
    8 replies | 99 view(s)
  • jim lee's Avatar
    08-08-2019, 10:22 PM
    There IS a jumper I need to cut Straight from my little picture card here.. Cut to seperate VIN fromVUSB, if using a battery charger or external power for USB Device mode. I'll try that. -jim lee
    6 replies | 78 view(s)
  • jim lee's Avatar
    08-08-2019, 09:10 PM
    Maybe I should start a new thread? Its all related though.. Same project: Moisture sensor as note above. Water pump, Motor Driver board and a Buck converter from 12V battery to 5V logic. Originally I designed this...
    6 replies | 78 view(s)
  • jim lee's Avatar
    08-08-2019, 08:38 AM
    Well I'm running this : Adafruit moisture sensor And it looks like its working fine. Well, if I fire it up with the line power 120AC->12DC->5DC->Teensy, everything seems to be happy. Sometimes, when just starting up the...
    6 replies | 78 view(s)
  • jim lee's Avatar
    08-08-2019, 05:57 AM
    Does the I2C NOT work when only running on USB? (Teensy 3.2) Wait! I think I figured out what was going on. Other circuits were drying to draw too much power. A better question would be, is there any way to tell...
    6 replies | 78 view(s)
No More Results
About jim lee

Basic Information

Statistics


Total Posts
Total Posts
116
Posts Per Day
0.12
Last Post
Teensy 2.0? Today 08:14 AM
General Information
Last Activity
Today 08:14 AM
Join Date
12-30-2016