Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • rcarr's Avatar
    11-11-2017, 01:29 PM
    Have you determined what parts of your code are using large amounts of time? You can use millis() or the elapsedMillis objects to get a timestamp and the start and end of sections of your code. How long is one pass...
    4 replies | 305 view(s)
  • rcarr's Avatar
    11-02-2017, 03:26 PM
    rcarr replied to a thread Arduino or C in General Discussion
    As a latecomer to Arduino with previous experience with Microchip devices, I view Arduino as a double edge sword. First it is just incredible that you can program a device as complicated as the Teensy processors...
    8 replies | 548 view(s)
  • rcarr's Avatar
    10-24-2017, 01:47 PM
    Download the datasheet for your part and look at control register 2 for the UART. I am looking at the datasheet for the Teensy 3.6 and it has separate enable bits for the TX and RX, so it looks promising that you can...
    3 replies | 199 view(s)
  • rcarr's Avatar
    10-15-2017, 05:56 PM
    That is an interesting module. Did you jumper the pins for 3.3 volt operation? The spec write up says Optimal sensing distance: 0.125" (3 mm). Try moving a piece of white paper very close to the unit.
    25 replies | 1391 view(s)
  • rcarr's Avatar
    10-10-2017, 01:37 PM
    Although manchester encoding is just a hardware encoding method the underlying data stream is usually a synchronous data stream. If you look at the linked Atmel document, you will see that the first thing they do is...
    17 replies | 1133 view(s)
No More Results
About rcarr

Basic Information

Statistics


Total Posts
Total Posts
68
Posts Per Day
0.36
Last Post
Teensy 3.6 MIDI keyboard with knobs and buttons latency issue 11-11-2017 01:29 PM
General Information
Last Activity
Today 01:27 PM
Join Date
05-17-2017