Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • Armadafg's Avatar
    05-03-2019, 07:40 AM
    ok, I deepened my diagnosis. I did tests with 2 different MLK02 and tested the conections. The pin rest and Program it is well to connect to the MKL02 and it does not short to GND. When I feed the chips in...
    16 replies | 542 view(s)
  • Armadafg's Avatar
    04-25-2019, 11:46 PM
    Hi, At this time i have the case where the program pin is at 0volt. I was able to send a program once but after nothing. I tested all possible combinations with the button programe and reset but nothing happens. Is it...
    16 replies | 542 view(s)
  • Armadafg's Avatar
    04-01-2019, 09:40 AM
    Thank you very much for your help. The voltage goes well to 0 or 3.3volt in function of the position of my buttons I will check but it seems to me that this is actually what I had to observe, the reset does not...
    16 replies | 542 view(s)
  • Armadafg's Avatar
    04-01-2019, 09:02 AM
    Hi everybody, I corrected the problem on my circuit board, that said my pc detect well something on the USB port but it is not the teensy. I don't know what it is and I don't know how to solve it. I try with all...
    16 replies | 542 view(s)
No More Results
About Armadafg

Basic Information


Total Posts
Total Posts
Posts Per Day
Last Post
Custom teensy 3.6 not work 05-03-2019 07:40 AM
General Information
Last Activity
05-05-2019 11:02 PM
Join Date