Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • drjohn's Avatar
    02-10-2019, 07:31 PM
    The slide pot IS the divider: at the middle there'd be 5K above and below the wiper. Having the pull-up on would add a third resistor and make it less than linear. that might be desirable in some corner cases,...
    6 replies | 122 view(s)
  • drjohn's Avatar
    01-27-2019, 06:18 AM
    Having tried to make pinball machine flippers with many speeds and torques of servo and failing, I feel a solenoid is likely the right path for percussion. They offer impressive speed and power, and come in a large...
    6 replies | 147 view(s)
  • drjohn's Avatar
    01-21-2019, 05:34 PM
    Good points, Oddson. Additionally...Although I didn't try too many cards, speed is dependent on type of the words of Paul, from
    3 replies | 118 view(s)
  • drjohn's Avatar
    01-21-2019, 04:47 PM
    This may be pedantic, but...I'd use the SD card slot on the 2.5 rather than the one on the audio shield because it has a wider/faster interface to the SD card, decreasing latency and increasing speed. I have not seen...
    3 replies | 118 view(s)
  • drjohn's Avatar
    01-18-2019, 10:10 PM
    drjohn replied to a thread Midi in Audio Projects
    Since you have a Teensy 3.6, it can act as host. You might need a cable: and the pins. This example code may help: Examples>USBHost_t36>MIDI>InputFunctions
    3 replies | 132 view(s)
No More Results
About drjohn

Basic Information

About drjohn
Olympia, WA
Musical interfaces, MIDI, babies


Total Posts
Total Posts
Posts Per Day
Last Post
MIDI Faderbox fader choice 02-10-2019 07:31 PM
General Information
Last Activity
Yesterday 07:10 AM
Join Date