Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • Dulz's Avatar
    05-17-2020, 09:51 AM
    Dulz replied to a thread Rotary encoder find in Project Guidance
    Yeh its going crazy, after i put the delay on there it showed that pattern.
    13 replies | 296 view(s)
  • Dulz's Avatar
    05-17-2020, 09:39 AM
    Dulz replied to a thread Rotary encoder find in Project Guidance
    Thanks for the replys guys, I played around a bit longer yesterday and was able to get it reading both ways by putting a capacitor in the line with a pullup resiter as well, however i wouldn't say it was a reliable...
    13 replies | 296 view(s)
  • Dulz's Avatar
    05-16-2020, 02:05 AM
    Dulz replied to a thread Rotary encoder find in Project Guidance
    I put a 10k pullup resistor to pins 9 and 10, which really smoothed it out, otherwise it was going crazy counting when it wasnt even spinning. But only counts up.
    13 replies | 296 view(s)
  • Dulz's Avatar
    05-16-2020, 02:03 AM
    Dulz replied to a thread Rotary encoder find in Project Guidance
    #define ENCODER_OPTIMIZE_INTERRUPTS #include <Encoder.h> // Change these pin numbers to the pins connected to your encoder. // Best Performance: both pins have interrupt capability // Good Performance: only...
    13 replies | 296 view(s)
  • Dulz's Avatar
    05-16-2020, 01:55 AM
    Dulz replied to a thread Rotary encoder find in Project Guidance
    Hi Guys, thanks for your replys. I have had a go at connecting it to a teensy 3.6 using the wiring vjmuzik gave above. It appears to be counting, however only counting upwards. If i spin it either way then it goes...
    13 replies | 296 view(s)
  • Dulz's Avatar
    05-13-2020, 06:41 AM
    Dulz replied to a thread Rotary encoder find in Project Guidance
    From what i can see on the instructions, it says 12v-24v. I'm assuming that is the red wire? I also am assuming that the others are signal wires and that they wouldn't need 12v?
    13 replies | 296 view(s)
  • Dulz's Avatar
    05-13-2020, 06:39 AM
    Dulz replied to a thread Rotary encoder find in Project Guidance
    13 replies | 296 view(s)
  • Dulz's Avatar
    05-13-2020, 06:38 AM
    Dulz replied to a thread Rotary encoder find in Project Guidance
    13 replies | 296 view(s)
  • Dulz's Avatar
    05-13-2020, 06:32 AM
    Hi everyone, i found this rotary encoder at work and would like to attempt to read it. The details i can make out are: Matsushita ER24 (from research i believe is panasonic) AER12122 The instructions i will...
    13 replies | 296 view(s)
No More Results
About Dulz

Basic Information

Statistics


Total Posts
Total Posts
29
Posts Per Day
0.06
Last Post
Rotary encoder find 05-17-2020 09:51 AM
General Information
Last Activity
05-18-2020 06:32 AM
Join Date
01-31-2019