Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • anku's Avatar
    04-11-2019, 12:02 PM
    Thanks, just ordered one! And thank you for the welcome! For quite some time I've been looking for a project where the Nanos that are usually my go-to choice wouldn't be sufficient anymore. Coming from a rather...
    10 replies | 233 view(s)
  • anku's Avatar
    04-11-2019, 10:46 AM
    Okay, thanks for the heads up. What would you recommend instead? I wasn‘t planning on going higher than 24V on the input. 32V just seemed save..
    10 replies | 233 view(s)
  • anku's Avatar
    04-11-2019, 07:55 AM
    Thank you for your advice! There seems to be no need for any 5V lines anymore, so I'll stick to 3.3V entirely. Do you have any recommendations for a reliable regulator? I was looking at the TSR 1-2433 with an output...
    10 replies | 233 view(s)
  • anku's Avatar
    04-10-2019, 06:57 PM
    Thanks for you answer! Ok, I think I was not clear about that. I was talking about the stepper driver logic part being powered by the LC. The motor powering part on the drivers are directly fed by the batteries @24V....
    10 replies | 233 view(s)
  • anku's Avatar
    04-10-2019, 10:59 AM
    Hello, coming from Arduino, this is my first project with a Teensy. I understand that the Teensy LC likes 3.3V on all pins, so all components connected must work at that voltage. The primary power source will be...
    10 replies | 233 view(s)
No More Results
About anku

Basic Information

About anku
Location:
Cologne (DE)

Statistics


Total Posts
Total Posts
5
Posts Per Day
0.11
Last Post
Teensy LC: power converter question 04-11-2019 12:02 PM
General Information
Last Activity
05-21-2019 08:05 AM
Join Date
04-10-2019