Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • ChrisAldridge's Avatar
    09-27-2019, 05:03 AM
    Hi, I am connecting a T4 to a Xilinx S7 FPGA by the T4's I2S link (DOUT2, LRCLK2, BCLK2, DIN2), so I2S link 2. I don't have any audio shield, so cannot work directly from the examples given. I want to use it in the...
    0 replies | 80 view(s)
  • ChrisAldridge's Avatar
    09-20-2019, 07:59 AM
    In answer to my last question, if the device at the slave address does not ACK (produce an active low bit at the ack position of the bus protocol) , then no data will be sent over the link with the Wire.write()...
    3 replies | 139 view(s)
  • ChrisAldridge's Avatar
    09-19-2019, 11:12 AM
    Thanks the code compiles when I use the functions in Wire, but now I have another question. When running the function Wire,begintransmission(). And I address a non existent I2C device on the bus. would the following...
    3 replies | 139 view(s)
  • ChrisAldridge's Avatar
    09-17-2019, 11:41 PM
    Is i2c_t3 the correct library for Teensy4 for I2C, because when I open the examples they do not compile. When I go through the .c and .h for that library I do not see references to T4. I have installed the...
    3 replies | 139 view(s)
No More Results
About ChrisAldridge

Basic Information

Statistics


Total Posts
Total Posts
7
Posts Per Day
0.05
Last Post
Getting Started with Audio for T4 09-27-2019 05:03 AM
General Information
Last Activity
09-27-2019 02:31 PM
Join Date
06-03-2019