Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • Rezo's Avatar
    10-15-2019, 08:08 PM
    So I got my Teensy to read the message transmitted from the Uno ("hello" over can every second) I had my Can Tx/Rx mixed up between the T3.2 and the TJA1050, and I added a 120ohm resistor between CANH and CANL. ...
    1 replies | 55 view(s)
  • Rezo's Avatar
    10-10-2019, 01:56 PM
    If you are connecting to a vehicle that supports OBD2 (IIRC anything manufacured after 2004), you need to request the data with the corresponding PID (https://en.wikipedia.org/wiki/OBD-II_PIDs - service 01). For this,...
    7 replies | 144 view(s)
  • Rezo's Avatar
    10-10-2019, 11:29 AM
    Hi all, Ove the last couple of months (on and off) I've been developing a project around OBD/UDS canbus based data display for my car (MQB VW) I started off with an Arduino Uno and an Elecfreaks Canbus shield as...
    1 replies | 55 view(s)
No More Results
About Rezo

Basic Information

Statistics


Total Posts
Total Posts
3
Posts Per Day
0.41
Last Post
Teensy 3.2 Canbus - Which FlexCan do I use? 10-15-2019 08:08 PM
General Information
Last Activity
Today 05:17 AM
Join Date
10-09-2019