GardG
Junior Member

OK, that was another rather embarrasing mistake from my side. I had moved my test sending over to a lighting console, and had made some mistakes in the network setup there, so the signal only reached the DMX node at 5...

Thanks a lot for the feedback! - Every 4 pixels should be the same – I'm using 144 LED/m strip for the sake of output power, and grouping them together in bunches of 4 to save DMX channels. - The strobe trigger...

So the application for this is to control some SK6812 strips and a Xenon strobe (trigger triac on pin 13) – I'm almost there (but with a bit of of code cleanup remaining!), using a mash-up of the included DMX receiver...

!!!!!!! It does!!! I tried a random selection of older versions with varying degrees of luck earlier, but not 3.1.1 apparently. Ace – I think this should get me through for this project. I don't think missing...

That's the MAX' DE/_RE pin, and setting it high … enables the line driver and disables the receiver. Yeah. That's a bit embarassing. I changed it back to LOW, as it should be, and I'm now back at the behaviour where...

Hi Shawn, thanks a lot for your reply! At the moment I'm using an ELC Checker DMX tester as the transmitter. I have also tried with a Madrix Plexus Artnet node, with the same results. In the final installation, we'll...